intermediate
General
AMS Performance Heat Exchanger Installation
180 minutes
3 tools
5 steps
Installation Steps
1
Front-End Removal:
Remove bumper, undertray, and crash beam. Disconnect coolant lines and drain system.
2
Remove OEM Heat Exchanger:
Unbolt and carefully slide out the factory unit.
3
Install New Heat Exchanger:
Mount supplied brackets; ensure tight fit behind bumper. Connect hoses and refill coolant.
4
Reassembly and Bleeding:
Reinstall crash beam and bumper. Bleed coolant system fully to prevent air pockets.
5
Notes:
Verify coolant flow and check for leaks during the first engine warm-up.
Rate This Guide
0.0 (0 ratings)
Sign in to rate this guide
Comments
Comments (0)
Sign in to leave a comment
Loading comments...
Tools Required
- Jack and stands
- Ratchet set (10mm–14mm)
- Drain pan for coolant
Need Installation Help?
Loading nearby installers...