beginner
General
Z1 Motorsports Cold Air Intake Installation (RZ34 / VR30DDTT)
60 minutes
3 tools
5 steps
Installation Steps
1
Remove Factory Airboxes:
Unclip MAF sensors and disconnect intake tubes. Loosen hose clamps and lift out both factory boxes.
2
Prepare New Intake Tubes:
Install rubber couplers and clamps. Transfer MAF sensors to new housings
3
Install Filter Assemblies:
Position new tubes into place, connect couplers to turbo inlets. Attach filters securely and verify no air leaks.
4
Reassembly:
Reconnect MAF sensors, re-clip wiring, and check for clearance.
5
Notes:
Check for check-engine lights after installation; re-seat MAF connectors if triggered.
Rate This Guide
0.0 (0 ratings)
Sign in to rate this guide
Comments
Comments (0)
Sign in to leave a comment
Loading comments...
Tools Required
- Socket set (8mm & 10mm)
- Flathead screwdriver
- Trim removal tool
Need Installation Help?
Loading nearby installers...